Special Price £39.99
Tesla Biturbo Mech Dual RDA Starter Kit is a powerful device that has the ability to fire two RDAs at the same time for greater vapor productions. Users can add two flavors e-liquid into RDAs and enjoy a complex and unique taste. The device is equipped with buttons for channel selection at the bottom, which allows users to know the usage of this device better. All of these are designed to provide you with an unbeatable taste and quality. Innovation leads to changing life.
Tesla Biturbo Mech Mod Operations:
1. Power On: Insert two 18650 high-drain batteries i nto the body of the device. The blue LED A and B will falsh 5 times to indicate the dual channels are started, and device will enter the mode of stand-by.(We recommend using high-drain 18650 batteries with rated discharge current>30A. Please be careful about the positive and negative signs inside the battery compartments.)
2. Power Off: Press the fire button for 5 times consecutively when the device is powerd on, and corresponding LED will flash for 3 times to indicate that the device is powered off.
3. Vaping: Press the fire button simultaneously as you vape and release the fire button when vaping is not required.
4. Working Mode Switch: Users can enjoy the switching among four working modes: opened channel A adn B / Opened Channel A / Opened Channel B / Closed channel A adn B. Press channel selection button A/B to open or close the channel A/B.
5. Charging: Remove the 18650 batteries from the device and recharge the batteries buy using an proper recharging device.
Tesla Biturbo Mech RDA Operations:
1. Steps for Installation: Before starting, make sure your hands are clean. Take RDA apart, install the pre-wrapped wire, and position and cut the ends of the wire off. Insert the cotton, and place it in the middle. Cut the cotton at an angle and make sure it's not too short or too long. Wet the coil with e-liquid and adjust the cotton.
2. Adjusting the Airflow: Adjust airflow through rotating the stainless tube, where a total of two airflow holes are located.
Tesla Biturbo Mech Starter Kit Protections
1. Over Puffing Protection: The device will deactivate after continuous puffing of more than 10 seconds. Then corresponding LED will flash for 8 times, and the device will enter the stand-by mode.
2. Reverse Connection Protection: If batteries are inserted incorrectly, the device will fail to power on and will prevent any damage to the chipset.
3. Low Voltage Alert: When the voltage drops below 7.5V, corresponding LED will flash for 15 times and the device will power off.
4. Atomizer Short-circuit Protection: When an atomizer short circuit occurs, corresponding LED will flash for 5 times rapidly and the device will enter the stand-by mode.
Tesla Biturbo Features & Spec:
1 or 2 RDAs Arbitrary Switch
Channel Selection Button
Dual 18650 Cells Setup
Connector Bridge For RDAs
Great Vapor Productions
Wide Bore Drip Tip
Airflow Control System
Enjoy Two Flavors Simultaneously
Biturbo Mech Mod
Dimension: 52*26*107mm(starter kit) / 52*26*88mm(Mod)
Material:Zinc Alloy(Die Cast)
Cell Type: 2 Hi-drain 18650 cell(Discharging current should be above 30A)
Thread Type: 510 thread
Min resistance: 0.1Ohm(Single RDA)/0.2Ohm(Dual RDAs)
Input Voltage Range: 6.0V~8.4V
Standby Current: < 5uA
LED Indicator: Blue
Protections: Over puffing protection/ Reverse connection protection/ Atomizer short-circuit protection/ Low voltage alert.
Biturbo Mech RDA
Adjustable Aiflow: Yes
1 * Biturbo Mech Mod
2 * Biturbo Mech RDAs
1 * Connector
1 * Drip Tip
4 * Clapton Wire
6 * Silicone Rings
1 * Screwdriver
8 * Screws
2 * Organic Cotton
1 * USER Manual
Our order cut-off point for all delivery services is 3pm (UK time) Monday – Friday
Standard Delivery, in most instances this is 1st class post & only applicable to 10ml e-liquid products. Estimated delivery of between 1-2 days.
Royal Mail 48 Tracked, estimated delivery of between 2-3 working days (no signature required) SMS and/or E-Mail Tracking Notifications & designate a safe place to leave your parcel.
Royal Mail 48 Tracked & Signed For, estimated delivery of between 2-3 working days (a signature is required) SMS and/or E-Mail Tracking Notifications.
Royal Mail Tracking Link – Please note that tracking numbers supplied will activate from around 4.30pm onwards.
Next Day Courier, sent via DPD, delivery estimate of the next working day, excluding Saturday & Sunday deliveries, (a signature is required) SMS and/or E-Mail Tracking Notifications.
DPD Tracking Link
*Please note that some areas of the UK are classed as remote & in these areas delivery may take 2 days, please contact us for further information or to check service availability in your area*
Special Offer Free Shipping, we will select the courier we feel will provide the best & most cost efficient service for both ourselves and our customers. As a guide, DIY kits will be sent via Next Day Courier, while smaller items will be sent via Royal Mail 48 Tracked.See More Information
Returns policy for defective or damaged goods
1) If you receive damaged or defective goods, or an item is missing from your parcel you must inform Vampire Vape via email or phone call within 48 hours. Claims made after this time period will not be accepted.
2) The goods must be returned to Vampire Vape. On receipt, we will test and inspect the product, if the item is defective we will offer you a replacement in the first instance, or if the product is no longer available we will issue a refund including your postage fees. If the goods are deemed not to be defective or the damage is caused by misuse, you will liable for any costs incurred returning the goods to us.
3) You must return the goods to us with the original order number via recorded delivery and fully insured for the full value of the goods. You have a duty to take reasonable care of any goods whilst they are in your possession.See More Information